Allied Vision Technologies GX1660C Spécifications télécharger pdf (Page 22)

GX1660 Technical Manual Page 22

Trouble Shooting

Is the camera getting power?

The Green LED is the camera power indicator. If unlit, check the power adaptor. If possible,

swap with one that is known to work. If using a custom power adaptor, be sure the adaptor

supports the voltage and power requirements of the camera . If the LED still does not light up,

contact AVT Canada Inc. support.

Is the camera powered, but not detected in SampleViewer?

Damaged or poor quality Ethernet cabling can result in no cameras found, dropped packets,

decreased bandwidth, and other problems. Use Cat5e or better cabling known to work.

Configure your NIC as outlined in “Gigabit Ethernet Setup For Windows”. It should have an IP

address of 169.254.x.x, Subnet Mask: 255.255.0.0. This is the AutoIP address range. If your

NIC has no access to a DHCP server, the camera will still be auto assigned an IP address. There

should be no gateway on your NIC.

Connect a single camera directly to your NIC, no hub/switch, and run the prosilica IP

Configuration utility (Start>Programs>Prosilica>GigEIPConfig or C:\Program

Files\Prosilica\GigEViewer\ipconfig.exe). You may need to wait up to 30 sec for camera to

appear.

A camera in DHCP (AutoIP fallback) mode.

• Camera is listed: Your camera and NIC must be on the same subnet, e.g.: NIC: IP

169.254.23.2 Subnet Mask: 255.255.0.0, Camera IP: 169.254.43.3 Subnet Mask: 255.255.0.0.

The following example is not on the same Subnet: NIC IP 169.250.23.2 Subnet Mask:

255.255.255.0, CamIP 169.254.13.0 Subnet Mask: 255.255.0.0. This can happen if you use a

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 41 42

Pas de commentaire

Allied Vision Technologies GX1660C Spécifications Page 22